MQ-4 Natural Gas Methane Gas Sensor Module

MQ-4 Natural Gas Methane Gas Sensor Module

Price: $0.83Sku: FA3057
Product Introduction

MQ-4 Natural Gas Methane Gas Sensor Module

Product Overview:

Sensitive material MQ- 4 gas sensors used in clean air, low conductivity tin oxide (SnO2). When there is an environment in which the combustible gas sensor, conductivity sensor with increasing concentration of combustible gases in air increases. Use simple circuit can convert the change in conductivity of the gas concentration corresponding to the output signal. MQ-4 Methane gas sensor of high sensitivity, propane, butane and has a good sensitivity. The sensor can detect a variety of combustible gases, especially natural gas, it is a low-cost sensor suitable for a variety of applications.
Gas can be used in homes and factories leakage monitoring device, suitable for the detection of liquefied petroleum gas, butane, propane, methane, smoke and the like


  • Using high-quality dual-panel design,with power indicator and TTL signal output instructions.
  • The switching signal having a DO (TTL) output and analog output AO.
  • TTL output valid signal is low. ( Low-level signal when the output light can be directly connected to the microcontroller or relay module )
  • Analog output voltage with the higher concentration of higher voltage
  • There are four screw holes for easy positioning.
  • Has a long life and reliable stability
  • Rapid response and recovery characteristic
Input voltage : DC5V Power consumption ( current ): 150mA
DO output : TTL digital 0 and 1 ( 0.1 and 5V)
AO output :0.1-0 .3 V ( relative to pollution ) , the maximum concentration of a voltage of about 4V
Special note: After the sensor is powered,needs to warm up around 20S,measured data was stable,heat sensor is a normal phenomenon,because the internal heating wire,if hot is not normal .


  • VCC: positive power supply (5V)
  • GND: power supply is negative
  • DO: TTL switching signal output
  • AO: analog signal output


    After the sensor is powered, need to warm about 20S, measured data becomes stable, heat sensor is normal.

Leave a Reply

Your email address will not be published.