ESP8266 ESP-13 WiFi Web Sever Shield for Arduino

ESP8266 ESP-13 WiFi Web Sever Shield for Arduino

Price: $4.76Sku: FA1011-1
Product Introduction

ESP8266 ESP-13 WiFi Web Sever Shield for Arduino

characteristic

1,WiFiUsing industrial grade chips ESP8266 Module for ESP-13 With metal shield, strong anti-interference ability;

2,Standard pin compatible Uno ,Mega2560 Main control panel,and UNO Connection using the voltage conversion chip, making 3.3V and 5V Compatible;

3,Serial port using dual dial switch control, so that the expansion of the board can be used as a separate Uno Expansion board use, can also be used as ESP8266 Expansion board use;

4,Real serial port WiFi,Program is not required for any configuration;

5,be based on Server Web to configure WiFi Parameters and serial port parameters;

6,Can be used as an independent ESP8266 Development board to use, download the official ATInstruction firmware, NodeMCU Open source firmware, etc;

7,Can be used as an independent Uno Extended board use, pin all extraction.

technical specifications

1,Wireless support 802.11 b/g/n Standard;

2,support STA/AP Two modes of operation;

3,built-in TCP/IP Protocol stack, you can configure a Socket;

4,Support standard Server TCP/UDP and Client;

5,Serial port baud rate support:1200/2400/4800/9600/19200/38400/57600/74800/ 115200 BPS;

6,Serial data bit:5/6/7/8A;

7,Serial parity check: no;

8,Serial stop bit:1/2A;

9,standard UNO ,Mega Pin spacing;

10, extraction Pin 2/3/4/5/6/7/8/9/10/11/12/13 ;

11, extraction GPIO 0/2/4/5/9/10/12/13/14/15/16/ADC/EN/UART TX/UART RX ESP8266;

12, RESET Reset;

13, KEY Key multiplexing configuration;

14, Two digit dialing switch and ESP8266 Serial port expansion switching;

15, WiFi Working current: continuous transmission:About 70mA (MAX 200mA Standby), standby:<200uA;

16, Wireless transmission rate:110-460800bps;

17, Working temperature:-40C~ +One hundred and twenty-fiveC

18, Module weight: About 70g

Leave a Reply

Your email address will not be published.